BMW R1200RT/R1250RT Forum

I found following torque values: Clutch Housing to Crank Shaft: 40Nm then 40 degrees (to replace rear main seal) Replace all M11X1.5X12.9 with new bolts (must not use old bolts) Balancing Shaft: M8X70: 10Nm then 90 degrees (replace the seal) Housing cover M6X20: 12Nm Gearbox to engine: M6X18: 19Nm P...

Hey fellows;

I have the replacement kit and all the seals. I was trying to find torque values of bolts the secure the clutch housing and flywheel cover in place. I think I will also have to remove weight balancer to replace bottom seal. Any help will be much appreciated.

Regards

Bought a CLA02600 package from beemershop and I’ve all the seals here. Now just need the torque values of all inside bolts. I’m ready to pack the bike back together. Does anyone knows the torque of these bolts?

Its a single dry plate. Attached pictures show clutch plate with pressure plate and housing cover sitting aside. The other picture shows the condition of the clutch plate. I purchased a CLA02600 kit from Beemershop along with new bolts for half the price. Ive searched the internet for correct torque...

This now brings me to the next question; is it wise to change just the clutch plate or should I change the pressure plate and housing as well?

As you may have already figured that this is my first mechanical battle this deep.

I see; that means it was probably rider’s fault for losing clutch at every 11K. He probably was riding half clutch most of the time causing it to run out of friction lot sooner.

Hello all; I purchased my 2014 R1200RTP from a City fleet auction. It was advertised that the clutch was replaced recently; which in my opinion caused the bid to go up higher than should have been. Anyway, I drove the bike a total of 3 or 4 times and then it lost power (engine sounded good) and smok...

Hello all; Finally found the courage and time to split the bike apart. While I was taking it apart, I felt that I was the first one pulling clutch out. My dilemma is as follow: I purchased this bike from a City fleet auction. It was advised that the clutch was replaced recently therefore the bid wen...

Hello everyone: This is my first post/ request. Most of the time, I was able to find answer easily from discussions in here. So here is my issue: I purchased a 2014 RTP from an auction placed by a City in TX with only 22K miles. They mentioned in their maintenance section that they had changed the c...