I was impressed how well all the fasteners came off.
Fitted my engine covers.
-
Sullivj
- Posts: 803
- Joined: Wed Jul 06, 2016 9:46 pm
- Location: Gatwick
- Has liked: 72 times
- Been liked: 71 times
Fitted my engine covers.
Found there was enough clearance to fit the LHS with the side panels in place, but the RHS needed a full front panel strip.
I was impressed how well all the fasteners came off.
I was impressed how well all the fasteners came off.
-
David.
- Subscriber
- Posts: 8342
- Joined: Fri Nov 07, 2014 7:29 pm
- Location: North Yorkshire
- Bike Model and Year: R1200RT (Camhead) 2012
- Been liked: 395 times
Re: Fitted my engine covers.
The LHS cylinder sits forward of the RHS one.Sullivj wrote:Found there was enough clearance to fit the LHS with the side panels in place, but the RHS needed a full front panel strip.
Quality screwed fasteners, none of the plastic push fit rubbish like on Jap. bikes.Sullivj wrote:I was impressed how well all the fasteners came off.
Last edited by David. on Sat Jul 30, 2016 7:50 pm, edited 1 time in total.
-
David.
- Subscriber
- Posts: 8342
- Joined: Fri Nov 07, 2014 7:29 pm
- Location: North Yorkshire
- Bike Model and Year: R1200RT (Camhead) 2012
- Been liked: 395 times
Re: Fitted my engine covers.
The picture is a "Hexhead" not a "Twin Cam" but the cylinder layout is the same.Sullivj wrote:Great pic.
Re: Fitted my engine covers.
DaygloDavid wrote: The LHS cylinder sits forward of the RHS one.
WHAT?? They're not perfectly in line? Must be a design flaw!
