Top Box Lid

[Lynxfixer]

Guys, I'm planning on carrying out a lighting mod to my top box that will necessitate removing the plastic lining from the lid. However , after removing all the screws, the lining still doesn't want to come out. Does anyone have instructions or a video on this? Wanted to ask before sticking a screwdriver down the side and breaking off a load of plastic tabs!!
Kind regards...........

[guest3074]

Which model\year of box?

[Lynxfixer]

2008

[guest3074]

If it's this box then I'm afraid you're going to struggle, it's held in place with double sided sticky tape. We have one at work that belongs to a colleague and we can't get it apart. 

[attach=1]

[Lynxfixer]

Bugger!! Guess I'm going to have to rethink my mod then. How about taking the bottom liner out, is that a bitch as well?

[guest3074]

I haven't dismantled the lower but I believe that can be done. See this here

[guest3167]

I did the same and just ran the wire through the top. The wire is secured to the inside of the top.




--Chris
Sent from my iPhone using Tapatalk

[guest3167]

I wanted to hide the wire away... but from discussions on the MOA board... I learned it was very difficult to get that lid apart.


Sent from my iPhone using Tapatalk