Laying Up/Winter Storage
Re: Laying Up/Winter Storage
It's all right for some and once upon a time I always rode in all but ice and snow.
Now I'm an old git .
Now I'm an old git .
Re: Laying Up/Winter Storage
RTman10 wrote: It's all right for some and once upon a time I always rode in all but ice and snow.
Now I'm an old git .
Try a heated jacket - it'll totally change your view of riding on a cold, crisp autumn day. It's more fun than the summer because the cyclists all stay at home!
- David.
- Subscriber
- Posts: 8342
- Joined: Fri Nov 07, 2014 7:29 pm
- Location: North Yorkshire
- Bike Model and Year: R1200RT (Camhead) 2012
- Been liked: 395 times
Re: Laying Up/Winter Storage
It's grim "Up North", near Barnard Castle, this morning.
Last edited by David. on Wed Nov 09, 2016 9:21 am, edited 1 time in total.
Re: Laying Up/Winter Storage
Got one. But it's all that cleaning that puts me off. Maybe I should consider smothering it in preservative goo and then just ride it. Or do you just put that on to store it.
- David.
- Subscriber
- Posts: 8342
- Joined: Fri Nov 07, 2014 7:29 pm
- Location: North Yorkshire
- Bike Model and Year: R1200RT (Camhead) 2012
- Been liked: 395 times
Re: Laying Up/Winter Storage
Rode out in the Yorkshire Dales in April this year (2016), still plenty of salt/grit on the roads, my RT was white all over, (normally blue).
Within a brick built garage, (attached to the house), condensation will exist, especially if a wet car is put away. A dehumidifier would solve the problem.
Nice to know there is some corrosion protection on the bike, for both scenarios.
Within a brick built garage, (attached to the house), condensation will exist, especially if a wet car is put away. A dehumidifier would solve the problem.
Nice to know there is some corrosion protection on the bike, for both scenarios.
Last edited by David. on Wed Nov 09, 2016 10:09 am, edited 1 time in total.
Re: Laying Up/Winter Storage
Serves you right for living up North. Suns out in Wiltshire, but a bit nippy, 3 degs 8) Off out on the bike later.
Re: Laying Up/Winter Storage
Casbar wrote: Serves you right for living up North. Suns out in Wiltshire, but a bit nippy, 3 degs 8) Off out on the bike later.
Rode the Surrey/Kent borders today. Once it warmed up (to 6 or7) it was a nice day for a ride...
Re: Laying Up/Winter Storage
richardbd wrote:
Rode the Surrey/Kent borders today. Once it warmed up (to 6 or7) it was a nice day for a ride...
On duty today, did a Blood Bank to Salisbury District hospital run. Was a good ride, very pleasant. Hopefully tomorrow will also be a nice day for my next shift
Re: Laying Up/Winter Storage
https://www.carcoon.com/carcoon-bikebubble
Have a look at this, best £250 I have ever spent
:enjoying:
Have a look at this, best £250 I have ever spent
:enjoying:
Life is like a toilet roll.. the closer to the end you get the faster it goes..
Re: Laying Up/Winter Storage
looks pretty though! Sun is out in Salisbury, although its going to be freezing next week apparently, but no snow.
Re: Laying Up/Winter Storage
I recently bought a 2015 r1200RT, and also lay my bikes up in the winter (I am in Ohio, and can't tolerate the cold at age 64 !)
On page 160 of the BMW owner's manual, it recommends 1) completely filling fuel tank, 2) removing battery, 3) covering metal parts with vaseline, 4) waxing surfaces if water will no longer bead up on the surface, and finally 5) jacking both wheels off of the ground. Personally, I have always left my batteries in (and on a trickle charger), and have never had an issue. In addition, I have never used vaseline to coat metal parts. Maybe it would be feasible to spray something like WD 40 on the metal instead. Any thoughts on this ? It is interesting that the BMW manual does NOT state anything about using a fuel stabilizer (such as StaBil, or similar product) ? I use either Stabil or similar products. Here is a link that might be of value concerning ethanol-based fuels.
http://www.fuel-testers.com/review_gas_ ... ducts.html
On page 160 of the BMW owner's manual, it recommends 1) completely filling fuel tank, 2) removing battery, 3) covering metal parts with vaseline, 4) waxing surfaces if water will no longer bead up on the surface, and finally 5) jacking both wheels off of the ground. Personally, I have always left my batteries in (and on a trickle charger), and have never had an issue. In addition, I have never used vaseline to coat metal parts. Maybe it would be feasible to spray something like WD 40 on the metal instead. Any thoughts on this ? It is interesting that the BMW manual does NOT state anything about using a fuel stabilizer (such as StaBil, or similar product) ? I use either Stabil or similar products. Here is a link that might be of value concerning ethanol-based fuels.
http://www.fuel-testers.com/review_gas_ ... ducts.html