Wrongmichaelc2710 wrote:Ones mapped and one isn't.
Nomichaelc2710 wrote:I'm not very good at this game am I.
Wrongmichaelc2710 wrote:Ones mapped and one isn't.
Nomichaelc2710 wrote:I'm not very good at this game am I.
Casbar wrote:But the uploading a map that nobody else can see and one size fits all is a little no, more than a little hard to believe, but I will never go there, so not my concern.
Casbar wrote:It's not so much about power, but more drivability, as the standard map on the LC is lean. I have only read good reports from owners that have had a remap by Hilltop.
RTLC Remapped, viewtopic.php?t=8Casbar wrote:I do agree the older bikes maps can be adjusted, but not the LC by an upload of a secret map.
David. wrote: RTLC Remapped, /viewtopic.php?t=8
David. wrote: The majority of positive posts on this forum about Hilltop remapping have been from owners of pre-LC RT's, including myself.
Those fewer LC owners have had early models, but still been satisfied with the results.
Dyno runs are probably for vanity or bragging rights, most owners are just looking to have the AFR corrected to make the bike nicer to ride, which it does.
Hilltop themselves have said that with the more modern bikes, "there is not much to be gained from stock".
The discussion mainly seems to be surrounding LC's not pre-LC bikes, mine is a 2012 Camhead.
Have Treetop etc. themselves been able to remap LC's with a positive outcome, rather than just slag off Hilltop.
David. wrote:Have Treetop etc. themselves been able to remap LC's with a positive outcome, rather than just slag off Hilltop.
Can the independent operator dyno runs be adjusted?Casbar wrote:The dyno runs done at Hilltop can be adjusted.
David. wrote: Can the independent operator dyno runs be adjusted?
David. wrote: Thank you for your input & debate. I'm now reassured that all these reported issues with Hilltop only relate to LC's.
Did you not bother getting yours done.MEM62 wrote:I asked him about the Hilltop remap and he stated that he owned one standard Camhead and one with a Hilltop remap (done by a previous owner).
He states that he cannot tell the difference.
How did you get on removing & replacing the centre stand. I looked at it and thought how do you replace the springs.MEM62 wrote:I have already had the centre stand powder coated because it rusted.
David. wrote: Did you not bother getting yours done.
How did you get on removing & replacing the centre stand. I looked at it and thought how do you replace the springs.
Seem to remember mentioning it to a BMW dealer, their reply was, it's a right chew on, leave it alone.