I have spent the last hour looking for a table or chart of torque settings for the R1250RT to limited avail, I have found a number of older and similar models listed but not an 1250RT.
I even tried to buy a service DVD which might have the data
There are a few in the owner’s manual and for the GS/A, does anyone have them please.
TIA
2020 R1250RT torque settings required
Re: 2020 R1250RT torque settings required
Since there are a few differences in the series of WetHead from the 2014-2018 the I have to the ShiftHead of 2019-2021, this torque sheet covers most of the things that are common.
Of course, the bearing block that holds the cams and the actuating solenoid are the significant differences, but they are still the same size fasteners—M6x35.
There are 3 studs to hold the exhaust to the head on the ShiftCam vs just 2 on the WetHead, so again minor differences.
This sheet should be a good starting point for what you need to do.
Hope it helps.
https://drive.google.com/file/d/1uE1bq-DROujPqhynenoNOTgYVauvauFK/view?usp=sharing
Of course, the bearing block that holds the cams and the actuating solenoid are the significant differences, but they are still the same size fasteners—M6x35.
There are 3 studs to hold the exhaust to the head on the ShiftCam vs just 2 on the WetHead, so again minor differences.
This sheet should be a good starting point for what you need to do.
Hope it helps.
https://drive.google.com/file/d/1uE1bq-DROujPqhynenoNOTgYVauvauFK/view?usp=sharing