Hi
Thought I would share how I have fixed my Hexcan and Innovv Camera on my new 1250
The hexcan is under the tail of the pillion seat. the supplied positive and negative are just about long enough to reach the battery terminal on the right hand side of the bike and used the redundant TPM connector under the rack and advised by innovv to connect to the canbus
- hexcan.jpg (346.95 KiB) Viewed 3510 times
The Innovv I had wired up before getting the hexcan so the switched supply for that taps into the rear aux socket again the main power is from the battery terminals on the right of the bike. The VR unit is between the tank and the rider seat secured with 3M dual lock tape
- innovv recorder.jpg (375.39 KiB) Viewed 3510 times
Front camera is secured on the right hand clear wind deflector ( UK so off side) using 2 x L pieces from the fittings kit to clamp to the plastic along with a DIY silicon stick in button cut in half just to add some stability and security
- front camera.jpg (282.66 KiB) Viewed 3510 times
Rear camera again some dual lock and for extra safety zip ties under the rear of the rack.
- rear camera.jpg (323.65 KiB) Viewed 3510 times
The remote is on the right hand infill panel again with dual lock
- remote.jpg (315.59 KiB) Viewed 3510 times
finally the GPS sensor is on the tail just under the rack near the rear light
SO far the hexcan is powering an additional stop light and a tomtom satnav may add some additional spot lights but thats for another day maybe
