Bought this 2009 RT, nice bike low miles BUT when I took the seats off it appears the owner cut the seat heat wires Ft and Rear for some other reason. I live in Florida so no real need for heated seats.
Can I use these wires (front brown & purple) or rear 4 wires to install extra driving lights ? Of the brown / purple which is hot and which is ground ?
Thanks for info.
Bob C
‘09 RT under seat wiring…
-
Roadshadowww
- Posts: 1
- Joined: Sun Nov 05, 2023 12:21 am
- Bike Model and Year: R1200RT 2009
-
Doctor T
- Posts: 1998
- Joined: Tue Dec 21, 2021 10:21 pm
- Location: west sussex
- Bike Model and Year: 2007 R1200RT SE
- Has liked: 1152 times
- Been liked: 306 times
Re: ‘09 RT under seat wiring…
I would find out whats the maximum volts/amps that the wires can deliver. Ive looked at mine on a 07 and the wires are on the thin side so suspect that they wouldn't be any good for a heavy load. By all means, give it a go. 2 things will happen either the canbus will trip of the wires will get hot and melt
Trust me I am a retired Doctor and lecturer at Oxford University of Structural and Mechanical/Electrical engineering.
"Blessed are the cracked, for they shall let in the light". Groucho Marx
"Blessed are the cracked, for they shall let in the light". Groucho Marx
-
Loopers
- Posts: 35
- Joined: Sat Aug 26, 2023 11:09 am
- Bike Model and Year: R1250RTLe 2023
- Has liked: 2 times
- Been liked: 11 times
Re: ‘09 RT under seat wiring…
You could possibly use the wires as the switched feed for a relay to power the lights but you'll still have to run some heavier cable from the battery to actually power the lights.