I started my 2005 1200RT last night after sitting for the winter. It started and ran fine. I pushed the BC button and the engine stopped. It owuld not restart nor would the satarter work. A further check showed that none of the right switches woulld work. That included the starter, BC, Heated grips, heated seat, right turn signal and turn signal cancel (the left side signal light would not cancel). The abs braking servo was still audible when the brake handle was pulled.
I checked and no codes are showing.
Any guidance on where to start?
Thanks
Randy
Right Handlebar switch
-
Doctor T
- Posts: 1985
- Joined: Tue Dec 21, 2021 10:21 pm
- Location: west sussex
- Bike Model and Year: 2007 R1200RT SE
- Has liked: 1133 times
- Been liked: 304 times
Re: Right Handlebar switch
Sounds like you will need to clean the button and wiring contacts
Trust me I am a retired Doctor and lecturer at Oxford University of Structural and Mechanical/Electrical engineering.
"Blessed are the cracked, for they shall let in the light". Groucho Marx
"Blessed are the cracked, for they shall let in the light". Groucho Marx