Page 1 of 1
Engine bars and highway pegs
Posted: Sat Aug 29, 2015 4:36 am
by mercator1
Has anyone put the Wunderlich bars and the Ilium Works highway pegs on their RTLC? Was wondering about the fitment, since the clearances seem pretty tight.
Re: Engine bars and highway pegs
Posted: Fri Feb 10, 2017 3:52 am
by Larsn
Wunderlich bars and Illium highway pegs are a happy combination. Love em.
Re: Engine bars and highway pegs
Posted: Sat Feb 11, 2017 1:23 pm
by lotoofla
The Wunderlich Bars are German TUV approved, and some what clumsy to install, they will save you a lot of money if the bike falls.
Re: Engine bars and highway pegs
Posted: Sat Feb 11, 2017 2:55 pm
by guest2360
Unless the bike rolls over the top of the bar. Then it's lots and lots of money.
Re: Engine bars and highway pegs
Posted: Sat Feb 11, 2017 9:35 pm
by richardbd
lotoofla wrote:
The Wunderlich Bars are German TUV approved, and some what clumsy to install, they will save you a lot of money if the bike falls.
RTMan's correct - the bars will won't add much to the protection in a drop, compared to head-guards. However, in an off at any kind of speed they may well lead to far more damage.
Quite apart from all that though, surely the most important thing is that they look dreadful!!!
:alas: :alas: :alas:
Re: Engine bars and highway pegs
Posted: Sun Feb 12, 2017 8:14 am
by guest3954
richardbd wrote:
Quite apart from all that though, surely the most important thing is that they look dreadful!!!
:alas: :alas: :alas:
Could go all the way - and mod a couple of these.
https://m.deere.co.uk/en_GB/products/at ... eries.page?