Radar Dector Wiring
- Oscar Nelsen
- Posts: 43
- Joined: Sat May 28, 2016 5:13 am
Radar Dector Wiring
Where should I hardwire my Valentine 1? Directly to the battery, tap the Power Socket wire, tap a parking light wire (did this on my FJR)?
2016 RT
-
- Posts: 603
- Joined: Sun Jan 31, 2016 9:44 am
- Location: North London
- Bike Model and Year: 1250RT 2019
- Been liked: 21 times
- Oscar Nelsen
- Posts: 43
- Joined: Sat May 28, 2016 5:13 am
Re: Radar Dector Wiring
That sounds logical.
My search for answers found there is an unused power connector on the left side. I am going to try to find that and just run wire to the right side (via CAN-BUS GPS/Gadget Power Pigtail part #83300413585) where the mount is installed. If I cannot locate that connector, I am going to tap the power socket. Thanks for your help.
My search for answers found there is an unused power connector on the left side. I am going to try to find that and just run wire to the right side (via CAN-BUS GPS/Gadget Power Pigtail part #83300413585) where the mount is installed. If I cannot locate that connector, I am going to tap the power socket. Thanks for your help.
2016 RT
Re: Radar Dector Wiring
I tapped into the same wire as my P3 lights, it's the plug under the front seat, mines a 15 model, skene design install instructions point out the location and color of wire
Be aware power will stay on for 30 seconds after turning off ignition switch
Be aware power will stay on for 30 seconds after turning off ignition switch
Jim
- Oscar Nelsen
- Posts: 43
- Joined: Sat May 28, 2016 5:13 am
Re: Radar Dector Wiring
Oscar
P3 lights are a added brake light
Made by a company called Skene designs
Jerry Skene the owner makes a great deal of different lights for many motorcycles all high quality
P3 lights are a added brake light
Made by a company called Skene designs
Jerry Skene the owner makes a great deal of different lights for many motorcycles all high quality
Jim
- Oscar Nelsen
- Posts: 43
- Joined: Sat May 28, 2016 5:13 am
- Oscar Nelsen
- Posts: 43
- Joined: Sat May 28, 2016 5:13 am
Re: Radar Dector Wiring
Tapped into the Powerlet wire for +12; used the fairing strap for ground.
Made a cradle for the Helmet Assisted Radar Detection helmet display transmitter and taped that to the power connector for the V1.
The detector mount is an old Spider that I could not find on their website. Longer Allen bolts and spacers replace the stock bolts.
Made a cradle for the Helmet Assisted Radar Detection helmet display transmitter and taped that to the power connector for the V1.
The detector mount is an old Spider that I could not find on their website. Longer Allen bolts and spacers replace the stock bolts.
2016 RT