Page 1 of 1

Grip Puppies installation question

Posted: Sat Jul 23, 2016 11:04 pm
by Methos1979
Just got some new Grip Puppies and they seem like they might be a little long, like a half inch. For those that have installed these did you trim them to size first or just squish them on?

Sent from my SM-N900V using Tapatalk


Re: Grip Puppies installation question

Posted: Sat Jul 23, 2016 11:10 pm
by T6pilot
Trimmed before install

Re: Grip Puppies installation question

Posted: Sun Jul 24, 2016 10:03 am
by falconmick
Trim and then use washing up liquid or  hair lacquer to help them into place.

Re: Grip Puppies installation question

Posted: Sun Jul 24, 2016 6:26 pm
by Peter Baker
Yes cut to length, having done a couple of them now on various bikes I tend to error cutting them too long the first time as you can always trim them again...  Peter

Re: Grip Puppies installation question

Posted: Sun Jul 24, 2016 8:25 pm
by Methos1979
Thanks to all. Trimmed them to size, installed in minutes, test rode for two hours and promptly cut them off. They my hand go numb faster! Who knew?

Re: Grip Puppies installation question

Posted: Mon Jul 25, 2016 6:22 am
by Nobby
I only cut the one on the RHS to make sure it didn't stop the mechanism working properly.

Re: Grip Puppies installation question

Posted: Mon Jul 25, 2016 7:53 am
by Stratman
I fitted some the other weeks and they stopped all the tingling/numbness, even after a 5 hour ride.

Re: Grip Puppies installation question

Posted: Mon Jul 25, 2016 8:55 am
by Casbar
Stratman wrote: I fitted some the other weeks and they stopped all the tingling/numbness, even after a 5 hour ride.

They defiantly helped with my tingling fingers. I found that if you move your grip on the throttle a little out, it helps a lot, and I only get tingling in at certain revs. I never have an issue with the left grip, just the throttle. They have helped a lot and if I move my grip and don't grip to tight they are fine

Re: Grip Puppies installation question

Posted: Mon Jul 25, 2016 1:53 pm
by MacJ
I followed the tip I found on the forum and bought a couple of rolls of Dunlop Raquet Handle tape. (£2.79 a roll at Sports Direct) Its nicely padded and self adhesive. With a bit of care( and a few dry runs) you can get a really nice finish. It makes the grips that much fatter and reduces any vibes.


I haven't tried whacking any balls with the handlebars though! ;)

Re: Grip Puppies installation question

Posted: Sun Jul 31, 2016 12:27 am
by Simon
Always painful to whack balls with the handlebars!