Page 1 of 1

Fitted my engine covers.

Posted: Sat Jul 30, 2016 7:08 pm
by Sullivj
Found there was enough clearance to fit the LHS with the side panels in place, but the RHS needed a full front panel strip.


I was impressed how well all the fasteners came off.


Image


Image

Re: Fitted my engine covers.

Posted: Sat Jul 30, 2016 7:46 pm
by David.
Sullivj wrote:Found there was enough clearance to fit the LHS with the side panels in place, but the RHS needed a full front panel strip.
The LHS cylinder sits forward of the RHS one.

Image
Sullivj wrote:I was impressed how well all the fasteners came off.
Quality screwed fasteners, none of the plastic push fit rubbish like on Jap. bikes.

Re: Fitted my engine covers.

Posted: Sat Jul 30, 2016 8:08 pm
by Sullivj
That explains it. Great pic David - thanks.

Re: Fitted my engine covers.

Posted: Sat Jul 30, 2016 9:14 pm
by David.
Sullivj wrote:Great pic.
The picture is a "Hexhead" not a "Twin Cam" but the cylinder layout is the same.

Re: Fitted my engine covers.

Posted: Sun Jul 31, 2016 9:20 am
by richardbd
DaygloDavid wrote: The LHS cylinder sits forward of the RHS one.

Image

WHAT?? They're not perfectly in line?  Must be a design flaw!


;) ;)