BMW R1200RT/R1250RT Forum

Hi does anyone know if I can obtain the connections to crimp on the spark plug wires like in the pics below?  I had a damaged spark plug connector but managed to source a new a one.  Now  I need these to replace the original crimped ones as 1 is damaged


Sent from my iPad using Tapatalk

Have you got a new 3 pin plug like this (complete with wires) & wish to splice it in to the wiring harness.

Hi David yes, I got this from Motorwerks it's fine but I don't like the way the earth has a terminal to secure to a part of the engine or frames, rather than ready to splice.. I don't have any terminals like in your pic. So can't chop it and keep it within the  conduit {\rtf1\ansi\ansicpg1252
{\fonttbl\f0\fnil\fcharset0 TimesNewRomanPSMT;}
{\colortbl;\red255\green255\blue255;\red0\green0\blue0;}
\deftab720
\pard\pardeftab720\qc\partightenfactor0

\f0\fs64 \cf0 \expnd0\expndtw0\kerning0
\outl0\strokewidth0 \strokec2 \pard\pardeftab720\qc\partightenfactor0
\cf0 \strokec2 \
}


Sent from my iPad using Tapatalk

Is this the type of connector you're after.

I don't think it pasted well, what I have is the kit from Motorwerks I put the link below.

https://www.motorworks.co.uk/vlive/Shop ... 0&spPage=2

It is not the same as the kit in your picture, I would prefer to splice in the earth too but this one has a ring type terminal for securing to the bike, meaning 2 of the 3 wires will be in the harness conduit then the 'earth' I will need to bolt to the engine or frame, which will work fine but will not look the best.  I want to be able to either exchange the actual terminals that are used in the coil connectors thus not requiring the splice, or splice all 3 wires so they are all in the conduit. Any ideas?





Sent from my iPad using Tapatalk

Is this what you got from Motorworks.

Yep that's it


Sent from my iPad using Tapatalk

OK, cut off the original damaged 3 pin plug, remove the terminals from the Motorworks supplied repair kit, solder the 3 wires from the two items together using heat shrink for insulation, hopefully, the conduit will slide over the re-made connections, if necessary stagger the lengths so the joint area doesn't become too bulky.

How to use heat shrink: https://www.youtube.com/watch?v=LD9kBax1DDk

Cheers David I think that's the way I will go ..


Sent from my iPad using Tapatalk

Vehicle Wiring Products, http://www.vehicle-wiring-products.eu/

I have just ordered this from eBay which looks like the same connectors as used in the spark plug connector for the sum of £4.24! Hope fully I can trim the original harness and fir these into the new connector. I will keep you posted when they arrive


Sent from my iPad using Tapatalk

Looks similar to this from VWP, http://www.vehicle-wiring-products.eu/p ... connectors