Changing headlight setup on an '09
Posted: Mon Sep 12, 2016 7:25 am
Hi
I have an '09 rt-p currently with HIDs (reflector design) for dipped and LED for my main beam.
What I was wondering is if I was to change all 3 lights to Projector LED headlights, but switching the 2 outer beams to Main beam LEDs and one dipped LED in the middle, emulating the '14 RT and K16s, with angel eyes as side lights around the main beam projectors.
On a traditional wiring set up it would just mean splicing and dicing a wires together but I'm not sure on the CANBUS system how difficult/different it would be, as the Canbus needs to be told there will only be one return for the dipped rather than 2, and 2 for main beam instead of 1.
Can I reprogram the CANBUS computer to just send the electrical signals to the other bulb (also changing the destination of the main beam switch - so the canbus computer decides which bulbs to turn on and the switch just tells it to light the extra circuit) or will it be a bit of programming and modifying the wiring setup too.
I know this is likely to cost a lot but I'm just trying to find out if its possible. The headlight unit side of it (projector and angel eyes) won't be a problem if I go ahead with it, just worried about the bike side of it
Many thanks
Mark
I have an '09 rt-p currently with HIDs (reflector design) for dipped and LED for my main beam.
What I was wondering is if I was to change all 3 lights to Projector LED headlights, but switching the 2 outer beams to Main beam LEDs and one dipped LED in the middle, emulating the '14 RT and K16s, with angel eyes as side lights around the main beam projectors.
On a traditional wiring set up it would just mean splicing and dicing a wires together but I'm not sure on the CANBUS system how difficult/different it would be, as the Canbus needs to be told there will only be one return for the dipped rather than 2, and 2 for main beam instead of 1.
Can I reprogram the CANBUS computer to just send the electrical signals to the other bulb (also changing the destination of the main beam switch - so the canbus computer decides which bulbs to turn on and the switch just tells it to light the extra circuit) or will it be a bit of programming and modifying the wiring setup too.
I know this is likely to cost a lot but I'm just trying to find out if its possible. The headlight unit side of it (projector and angel eyes) won't be a problem if I go ahead with it, just worried about the bike side of it
Many thanks
Mark