Page 1 of 1
Top Box Lid
Posted: Mon Oct 10, 2016 4:56 pm
by Lynxfixer
Guys, I'm planning on carrying out a lighting mod to my top box that will necessitate removing the plastic lining from the lid. However , after removing all the screws, the lining still doesn't want to come out. Does anyone have instructions or a video on this? Wanted to ask before sticking a screwdriver down the side and breaking off a load of plastic tabs!!
Kind regards...........
Re: Top Box Lid
Posted: Mon Oct 10, 2016 5:49 pm
by guest3074
Which model\year of box?
Re: Top Box Lid
Posted: Mon Oct 10, 2016 6:28 pm
by Lynxfixer
2008
Re: Top Box Lid
Posted: Mon Oct 10, 2016 6:34 pm
by guest3074
If it's this box then I'm afraid you're going to struggle, it's held in place with double sided sticky tape. We have one at work that belongs to a colleague and we can't get it apart.
[attach=1]
Re: Top Box Lid
Posted: Mon Oct 10, 2016 6:42 pm
by Lynxfixer
Bugger!! Guess I'm going to have to rethink my mod then. How about taking the bottom liner out, is that a bitch as well?
Re: Top Box Lid
Posted: Mon Oct 10, 2016 7:54 pm
by guest3074
I haven't dismantled the lower but I believe that can be done. See this
here
Top Box Lid
Posted: Mon Oct 10, 2016 9:21 pm
by guest3167
I did the same and just ran the wire through the top. The wire is secured to the inside of the top.
--Chris
Sent from my iPhone using Tapatalk
Re: Top Box Lid
Posted: Mon Oct 10, 2016 9:30 pm
by guest3167
I wanted to hide the wire away... but from discussions on the MOA board... I learned it was very difficult to get that lid apart.
Sent from my iPhone using Tapatalk