Page 1 of 1

Help for Fenix bullets fog lights and camera installation

Posted: Sat Oct 29, 2016 3:05 am
by Letsride
Hello



New to bmw R1200rt, I would like to install some new Fenix Bullit fog lights on my 2016 rt, not familiar
With Bmw electricals. anybody have a video or pictures of an installation looking at the 12 v, the batterie
Is hard to get to.


I also have a Jvc camera that Inwould like to use to film my rides, any installation suggestions


Thank you again
Claude G.

Re: Help for Fenix bullets fog lights and camera installation

Posted: Sat Oct 29, 2016 10:28 am
by guest3074
You don't need to remove the battery to gain access to the positive terminal, just to the right of the battery is a small round plastic cover over a terminal, this is the main positive lead from the battery so pull off the plastic cover and you can undo the terminal to connect your lead  :)

Re: Help for Fenix bullets fog lights and camera installation

Posted: Sat Oct 29, 2016 8:43 pm
by Maz12
Benchmark wrote: You don't need to remove the battery to gain access to the positive terminal, just to the right of the battery is a small round plastic cover over a terminal, this is the main positive lead from the battery so pull off the plastic cover and you can undo the terminal to connect your lead  :)
Wish I'd known that when I was putting the lead on for my heated gear

Re: Help for Fenix bullets fog lights and camera installation

Posted: Fri Nov 25, 2016 4:14 am
by Rossyuk39
If you are installing many electrical "farkles", you could consider using a fusebox or distribution box (http://www.sportouring.co.uk/product-ca ... tions/sps/) and using a trigger to energise it when the ignotion is switched on. I have used one fro my Autocom, Ride+ camera, driving lamps and heated gear wiring looms.

Hope this helps.......