Page 1 of 1
Black Widow exhaust
Posted: Sun May 17, 2020 1:14 pm
by chappers2a
Hi all, my exhaust headers on my 2016 RT are starting to show their age with rust spots that will not polish out. I am considering replacing them with some stainless steel ones made by Black Widow. Has anybody done this and if so how do they measure up for quality , keeping them clean etc. Also I would have to remove the flap thing in the exhaust-would that cause any problems? Thanks in anticipation.
Re: Black Widow exhaust
Posted: Sun May 17, 2020 1:31 pm
by David.
I haven't but Old-Git has, this thread from page 3 onwards might be of interest,
viewtopic.php?t=53.30
Re: Black Widow exhaust
Posted: Sun May 17, 2020 3:53 pm
by Old-Git
Yep most of my words are in there, but I forgot to mention I fitted a healtech exhaust flap eliminator, no warning lights.
https://www.ebay.co.uk/itm/BMW-R1200-R- ... 2749.l2649
And too early to say re cleaning etc.
Re: Black Widow exhaust
Posted: Sun May 17, 2020 5:11 pm
by chappers2a
Thanks Guys.
Re: Black Widow exhaust
Posted: Fri May 22, 2020 11:18 am
by tojjer
I had a black widow system on my Tracer 900 GT. Found the quality was good, welds etc as you'd want. Only thing they did discolour fairly quickly. Every time I cleaned them up, didn't take long to discolour again.
NEW:
Re: Black Widow exhaust
Re: Black Widow exhaust