Thread Lock during Spline Lube
-
- Posts: 41
- Joined: Tue May 16, 2023 2:25 pm
- Location: Wiltshire
- Bike Model and Year: R1250 RT LE 2019
- Has liked: 15 times
- Been liked: 14 times
Thread Lock during Spline Lube
A quick one I hope, I am about to do a Spline Service on a 2019 1250 RT and have watched a number of videos and searched for this but I am getting conflicting information. When you replace the Paralever Link onto the rear bevel I have found the torque of 56Nm but have seen everything from Red Loctite to Loctite 2701 (Green) to Blue 243 and nothing at all. What is the correct one to use as I plan to do this regularly each year? Thanks in advance.
- 60Aviator
- Posts: 57
- Joined: Sun Mar 28, 2021 10:17 pm
- Bike Model and Year: 2017 GSA & 2021 R1250RT
- Has liked: 8 times
- Been liked: 14 times
Re: Thread Lock during Spline Lube
Service manual says to use "Thread-locking compound (micro-encapsulated)", I use the blue stuff.
“I’d rather go down the river with seven studs than with a hundred poopheads” Charlie Beckwith
- Stu
- Administrator
- Posts: 1584
- Joined: Wed Jun 02, 2021 9:13 pm
- Location: Hull, UK
- Bike Model and Year: 2016 R1200RT
- Has liked: 555 times
- Been liked: 512 times
Re: Thread Lock during Spline Lube
Use a medium strength one which is blue I believe
Otherwise you will have a tough job the next time you want to remove it
Otherwise you will have a tough job the next time you want to remove it
-
- Posts: 41
- Joined: Tue May 16, 2023 2:25 pm
- Location: Wiltshire
- Bike Model and Year: R1250 RT LE 2019
- Has liked: 15 times
- Been liked: 14 times