Page 1 of 1
No start
Posted: Fri Jul 04, 2025 7:16 pm
by CanBstyle
Found an IAC unplugged on left cylinder. Plugged it in, now I have a no-start
Re: No start
Posted: Fri Jul 04, 2025 7:20 pm
by Stu
Hi and welcome
Have you tried unplugging it again?
Re: No start
Posted: Sun Jul 06, 2025 5:20 am
by CanBstyle
I did unplug it again. Thinking this might not be the problem.
Seems like something connected to the start /kill switch.
May be a poor ground. Randomly has no start, then I wait wiggle the wires on the right handle bar, nothing, then the abs light comes on the dash and it's ready to start.
One time it was idling and I bumped the right signal and it stalled. Another time I pushed the 'BC' button on the right handle and it stalled. I'm confused. If anyone recognizes these symptoms I'd appreciate any feedback
Re: No start
Posted: Sat Jul 12, 2025 9:17 am
by Stu
I think the next step would be to get the diagnostic codes read to see if there is any error codes as this could point you in the right direction