Greetings... I had a 2007 R1200RT, and it came with a standard height Corbin seat, super comfortable, but also a bit tall for my 30" inseam. I'm not a huge Crobin seat fan since they tend to be much harder than I am used to.

I came across a used "low" Corbin seat that really lowered the sitting ...

WELL DONE Randy.... I don't care for the thicker grip when using the grip-puppies, but I now am hoping I can find a thing tennis racket wrap that will lay over my somewhat-slick original grips. Your description of your problem and then solution was very helpful and well comunicated. Big help!!

Very nice work and explanation.

Thank you Costal Eddie...much appreciate your experience.

Greetings, and welcome to the forum. I'm not a frequent poster, but I might be able to assist you with your question.

I currently have and have loved my 1999 R1100r, that is, after I put the John Gemi chip in the computer and new injectors. Great introduction to BMW motorcycles. I also have a 2007 ...

Assuming you are only lowering the rear springs the kick stand will probably be ok most of the time and the center stand will be more difficult to in gage on the bike. You will need to be more careful with the kick stand.
Tenequip



Thank you Tenequiup for your comment. If I lower via the ...

I have had to do a few stands for a mate and they all varied depending on the angles they sat at

The best way I found was to cut the foot off and shorten the stand at the end a bit at a time until its right then weld the foot back on

You don't need to do the center stand it will still work, but ...

Greetings Guys and Gals, I am considering lowering my 2007 RT by installing the EPM Performance HyperPro -1" lowering springs. Even though the EPM people say that the bike will sit unloaded at about the same height as a stock bike, I have also read a number of people have needed to shorten their ...