No start

[CanBstyle]

Found an IAC unplugged on left cylinder. Plugged it in, now I have a no-start

[Stu]

Hi and welcome

Have you tried unplugging it again?

[CanBstyle]

I did unplug it again. Thinking this might not be the problem.
Seems like something connected to the start /kill switch.
May be a poor ground. Randomly has no start, then I wait wiggle the wires on the right handle bar, nothing, then the abs light comes on the dash and it's ready to start.
One time it was idling and I bumped the right signal and it stalled. Another time I pushed the 'BC' button on the right handle and it stalled. I'm confused. If anyone recognizes these symptoms I'd appreciate any feedback

[Stu]

I think the next step would be to get the diagnostic codes read to see if there is any error codes as this could point you in the right direction